Active Ingredients...Purpose Lice Killing Shampoo Piperonyl Butoxide (4%)...Lice Treatment Pyrethrum Extract (Equivalent to 0.33% Pyrethrins)...Lice Treatment Inactive ingredientsLice Killing Shampoo:Ammonium Laureth Sulfate, Dehydrated Alcohol, Fragrance, Isopropyl Alcohol, PEG-25 Hydrogenated Castor Oil, Polyquaternium-10, Purified Water. Lice & Egg Comb-Out GelPurified Water, Glycerin, Hydroxyethylcellulose, PG-Hydroxyethylcellulose Cocodimonium Chloride, Polysorbate 20, DM/DM Hydantoin, Fragrance, Iodopropynyl Butylcarbamate.
Directions Lice Killing Shampoo: â€¢ Important: Read warnings before use. Adults and children 2 years and over: Inspect check each household member with a magnifying glass in bright light for lice/nits (eggs) look for tiny nits near scalp, beginning at back of neck and behind ears examine small sections of hair at a time unlike dandruff which moves when touched, nits stick to the hair if either lice or nits are found, treat with this product Treat apply thoroughly to DRY HAIR or other affected area. For head lice, first apply behind ears and back of neck allow product to remain for 10 minutes, but no longer use warm water to form a lather, shampoo, then thoroughly rinse for head lice, towel dry hair and comb out tangles Remove lice and their eggs (nits) use a fine-tooth or special lice/nit comb. Remove any remaining nits by hand (using a throw-away glove) hair should remain slightly damp while removing nits if hair dries during combing, dampen slightly with water for head lice, part hair into sections. Do one section at a time starting on top of head. Longer hair may take up to 1 to 2 hours. lift a 1-to 2-inch wide strand of hair. Place comb as close to scalp as possible and comb with a firm, even motion away from scalp. pin back each strand of hair after combing clean comb often. Wipe nits away with tissue and discard in a plastic bag. Seal bag and discard to prevent lice from coming back. after combing, thoroughly recheck for lice/nits. Repeat combing if necessary check daily for any lice/nits that you missed a second treatment must be done in 7 to 10 days to kill any newly hatched lice if infestation continues, see a doctor for other treatments Children under 2 years: ask a doctor. Other informationLice Killing Shampooâ€¢ keep carton for important product informationâ€¢ see Consumer Information insert for additional informationâ€¢ avoid excessive heat. IMPORTANT: Read detailed directions inside before using. Completely eliminate lice from your family. Lice & Egg Comb-Out Gelâ€¢ Protect from freezing and excessive heat.â€¢ It is important to wash in hot water (130degF) all clothing, bedding, towels, and hair products (combs, brushes) used by infested persons.â€¢ Dry clean non-washable fabricsâ€¢ To eliminate infestation of furniture and bedding that cannot be washed or dry cleaned, a multi-use lice spray may be used.â€¢ This product does not kill lice or their eggs. Use this product only after treating with RIDÂ® Lice Killing Shampoo or other similar product. Home Lice, Bedbug & Dust Mite SprayShake well before using. Remove protective cap, hold container upright with nozzle away from you. Depress valve and spray from a distance of 8-10 inches (12-15 inches for baseboards, moldings and floors). Test product on an inconspicuous area before applying to check for possible staining or discoloration. Inspect again after drying. Spray to the point of dampness but not run-off. Over application may cause damage. Will not stain surfaces or fabrics where water alone causes no damage. Lice & Egg Comb-Out GelUse: To make egg and nit removal from the hair faster and easier. Home Lice, Bedbug & Dust Mite SprayTo Kill House Dust Mites (Dermaptophagoides spp.): RIDÂ® Home Lice Bedbug & Dust Mite Spray controls house dust mites that may cause asthma, hay fever, rhinitis, watery eyes and sneezing. One treatment lasts for up to 8 weeks. On Upholstered Furniture: test fabric in an inconspicuous area to insure dyes will not bleed. Spray all fabric surfaces until damp. Do not use on delicate fabrics. Allow furniture to dry thoroughly before using. On Carpets: Spray over entire carpet until damp. Hold the nozzle approximately 12 to 18 inches from the carpet surface and spray in a sweeping motion. Use an overlapping pattern to insure total coverage. After application, brush the surface of the carpet with a broom or brush to insure deep penetration, brush the surface of the carpet to dry thoroughly before reentering the treated area.
Always refer to the actual package for the most accurate information