Active Ingredients: Alkyl (50% C14, 40% C12, 10% C16) Dimethyl Benzyl, Ammonium Chlorides.... 0.26%, Other Ingredients: ...99.74%.
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. To Open Package: Open cap lid and pull up firmly on lid to remove the entire cap from the canister. Locate wipe at the center of the roll and insert corner of wipe through opening in lid. Do not push finger through opening. Replace lid. Pull sheet up and slightly to side. Always snap lid securely shut between uses to prevent moisture loss. For Surfaces that Come in Contact with Food: Use only on hard non-porous surfaces and rinse thoroughly with water.To Prevent the Growth of Mold and Mildew and their Odors: Pre-clean hard, non-porous surfaces. Wipe surface and allow to remain wet for 3 minutes. Allow surface to air dry. Repeat applications in weekly intervals or when mold and mildew growth appears.Not intended for personal hygiene. †† To Clean/Remove Allergens: Use fresh wipe on surface. Repeat for stubborn stains.To Sanitize / Disinfect: Pre-clean surface. Use enough fresh wipes to thoroughly wet surface. Surface must remain wet for the entire contact time.To Sanitize: Allow to remain wet for 30 seconds.To Disinfect: Allow to remain wet for 10 minutes. Allow surface to air dry. Toss dirty wipe away. Storage and Disposal: Dispose of wipe in trash after use. Close lid between uses to retain moisture. Non-refillable container. Do not reuse or refill this container. Discard in trash or offer for recycling.
Always refer to the actual package for the most accurate information