Active...PurposeBenzalkonium Chloride .10%...Antibacterial Inactive: Water, Cetrimonium Chloride, Glycerin, PEG-150 Distearate, Lauramine Oxide, Cocamide MEA, Fragrance, Propylene Glycol, Citric Acid, Tetrasodium EDTA, Acrylates/PEG-10 Maleate/Styrene Copolymer, Sodium Chloride, Tocopheryl Acetate, Aloe Barbadensis Leaf Juice, Hydrolyzed Collagen, PPG-12-Buteth-16, Magnesium Nitrate, Butylene Glycol, Phenoxyethanol, Methylchloroisothiazolinone, Magnesium Chloride, Ethylhexylglycerin, Potassium Sorbate, Methylisothiazolinone, Sodium Benzoate.
Directions â€¢ Wet hands. â€¢ Place hands under dispenser until soap is dispensed. â€¢ Wash hands. â€¢ Rinse hands with water. â€¢ Dry hands after rinsing. Other information: store at room temperature. ImportantDo not hold the dispenser from the middle while switched on as this will activate the sensor and soap will be dispensed.Before cleaning your counter, where the dispenser is placed, turn the dispenser off to prevent it from accidentally dispensing soap.Use only LysolÂ® No-TouchÂ® Refills in the No-TouchÂ® dispenser. Instructions for setting up1. Remove battery compartment.2. Pull out the protective red tab you'll see behind the batteries.3. Close the battery compartment. Press it firmly back to its place. Hold the dispenser over your palm. Slide the on/off switch to turn the dispenser on.4. Place the dispenser on counter.5. Place hand under the nozzle and in front of window until soap is dispensed. This device is battery operated. Use only alkaline batteries. Do not mix used batteries, batteries of different brands or different kinds. Ensure batteries are inserted correctly, aligning the (+) and Â(â€“) terminals as indicated. Ensure battery compartment is fully closed, with no space between it and the rest of the dispenser, so that it is moisture resistant. Maintain your dispenserDo not place the dispenser under running water.Do not place the dispenser inside the dishwasher.If the dispenser requires cleaning, switch it off, then wipe dispenser with a damp non-abrasive cloth and dry thoroughly. Ensure lens on underside of nozzle is free from soap build-up as this may unintentionally activate sensor.Do not place the dispenser in direct sunlight.Do not place the dispenser in standing water. Troubleshooting1. If the dispenser does not turn on:Check that the batteries are inserted in the correct orientation.2. If the dispenser does not dispense properly or does not dispense any soap at all:Ensure hand is placed between the nozzle and the window (see diagram).Switch the dispenser off. Clean as described in the section on "Maintaining Your Dispenser".If soap is dispensing unintentionally, see "Maintaining Your Dispenser". When the Hand Wash Refill is empty:Turn off the dispenser. Take the refill out. Replace only the LysolÂ® No-TouchÂ® Refill. Disposal: Remove batteries and dispose according to local regulations. Dispose empty bottle with your normal household rubbish or recycle according to local regulations. Dispose of automatic dispensing device in the appropriate recycling bin.
Always refer to the actual package for the most accurate information