Water, Ethoxydiglycol, C11-15 Pareth-3, Canola Oil Fatty Acids, Ethanolamine, p-Phenylenediamine, Resorcinol, Oleyl Alcohol, N,N-Bis(2-Hydroxyethyl)-p-Phenylenediamine Sulfate, m-Aminophenol, 4-Chlororesorcinol, Fragrance, 1-Naphthol, Sodium Sulfite, Erythorbic Acid, Cetyl Alcohol, Phenyl Methyl Pyrazolone, Trisodium EDTA, Polyquaternium-22, p-Aminophenol, 2-Amino-4-Hydroxyethylaminoanisole Sulfate, Panthenol, Tocopheryl Acetate, Aloe Barbadensis Leaf Extract, Anthemis Nobilis Flower Extract. Color developer: Water, Hydrogen Peroxide.
Preparation. Timer, clock or watch. Old towels (To cover counters to protect against stains). Old shirt (To cover you against stains). Moisturizer or petroleum jelly. (Smear along hairline to guard against stains). Damp paper towel (To wipe product off skin to prevent staining). Shampoo (Preferably for color-treated hair). 1. Smear a little moisturizer or petroleum jelly around your hairline to minimize staining. Cover countertops. 2. Wearing gloves, shake color base bottle. Pour the entire contents of color base bottle into applicator bottle. Replace caps. 3. Break off triangular tip of applicator bottle with thumb and index finger, pointing tip away from face. 4. Put your thumb on the applicator opening. Shake applicator bottle thoroughly to mix. Protect clothing and surfaces with old towels or shirt. Apply haircolor mixture right away for maximum effectiveness. Application. First time application. Important: Read thoroughly before starting. Apply to hair. 1. The color of the product mixture always looks different from the final, natural-looking results you'll get. Don't worry, this is normal. Squeeze on mixture. Start where hair is grayest. Then apply product to the rest of your hair. Gently massage product into hair. Do not add water. Cover all your hair. Don't forget the back and sides! Discard unused mixture. (Note: use as much mixture as needed to wet hair thoroughly and uniformly). 2. Important: start timing yourself after application is completed. Wait 5 minutes. Don't guess: use timer, clock or watch. Wait only 5 minutes or a bit less (to prevent haircolor from going too dark). Rinse, shampoo, dry and style. 3. In shower, rinse out product thoroughly until water runs clear. Shampoo and rinse again. We recommend Just For Men™ 2-in-1 shampoo & conditioner to keep your color looking fresh. Dry and style as usual. Repeat applications. Repeat applications (for current users with longer hair who see gray roots growing in). Apply quickly. Part hair every half inch or so and squeeze mixture only on gray roots. Do not lather in. Do not add water. Wait only 4 minutes. Then, during the next minute (the 5th minute) comb mixture through all your hair. Keep combing, wiping excess mixture from comb into hair. Discard unused mixture. Rinse and dry hair following "Rinse, shampoo, dry and style" directions (step 3 in "Application"). To keep some gray at the sideburns or temples, apply to those areas last, leave on for a few seconds and then wipe away. Remember to perform the allergy patch test 48 hours before each use. Easy step-by-step directions. Before you color read this first. Do a simple allergy patch test 48 hours before each application. Allergic reactions (itching, burning, redness) to permanent hair dyes, including Just For Men, can occur and in rare instances can be severe. A reaction can occur even though you had no reaction during previous usage. You must do this patch test on the inside bend of your elbow 48 hours ahead of each and every use in order to minimize the risk of an allergic reaction. (This is an allergy test, not a color preview.) 1. Wash test area. With mild soap and water, wash an area about the size of a quarter on the inside bend of your elbow. Pat dry. 2. Mix and apply product. Unscrew the entire cap from the natural color developer bottle (do not break off the tip at this point) and the color base bottle cap. Mix small, equal parts of the color base and the natural color developer in a plastic bowl with a plastic spoon. (Do not use metallic utensils.) Tightly recap both bottles. Apply mixture with a cotton ball or swab to a test area the size of a quarter on the inside bend of your elbow. Allow to dry. 3. Do not wash, cover or disturb test area for 48 hours. Examine the test area during the next 48 hours, if you get no reaction on the unwashed patch test site after 48 hours, go ahead with full application of Just For Men. Note: if at any time during the testing, you see redness or rash, or feel burning, itching or other irritation, you may be allergic. Stop!! Wash area immediately and keep it uncovered. You must not use just for men or any other haircoloring. 4. What to do if you have a reaction during or within the next 48 hours after coloring your hair. If during coloring you experience: Any stinging, burning and/or rash, shampoo out immediately and discontinue use as this may be an indication of a more serious reaction. Do not color your hair again before seeking medical advice. Rapidly spreading skin rash, dizziness, faintness, difficulty breathing, shortness of breath, tightness of chest, hives or swelling to eyes/face, blistering of skin or scalp weeping - seek immediate medical attention. If after coloring or on the following days you experience: problems such as skin itching, skin rash, swelling to eyes/face, blistering, skin or scalp weeping - seek immediate medical attention.
Always refer to the actual package for the most accurate information