All surfaces must be clean and tight fitting. Wear gloves to avoid skin contact. 1. Damp it! Lightly dampen one surface with water. 2. Glue it! Spread a thin layer of Gorilla Glue onto the other surface. 3. Clamp it!® Clamp for 30-60 minutes. Bond line improves with better clamping. Allow bond to cure for 24 hours. Cure time dependent on temperature and humidity. Clean-up: When wet glue off project immediately with dry cloth and/or paint thinner. Cured glue can be removed from work piece with chisel, scraper or sandpaper. See first aid section for removal from skin. Storage: After each use, wipe nozzle clean with a dry cloth. Squeeze all air from bottle. While still squeezing, tightly replace lid. Min. Coverage: 1/2 oz. per sq.ft. Open working time: Up to 5-10 minutes. Clamp: 30-60 minutes above 40°F. Best at room temperature. Cure time: 80% in 1 hour. Allow bond to cure for 24 hours. Full cure dependent on temperature and humidity. Moisture content: Best results from 10-25%. Below 10%, dampen surfaces with water.
Always refer to the actual package for the most accurate information