To apply: 1. Important: apply to a clean and dry surface. To clean, use a cloth dampened with water or isopropyl rubbing alcohol. Do not use household cleaners. Separate strips. 2. Remove blue liner. Press adhesive to hook. 3. Remove black "wall side" liner. 4. Press to surface for 10 seconds. 5. Important: for maximum holding strength slide hook off. 6. And press base firmly for 30 seconds. 7. Slide hook on. 8. Wait 1 hour before use. To remove: 1. Slide hook up to remove from mounting base. 2. Never pull strip towards you. 3. Hold base gently to prevent base from snapping fingers. Do not press base against wall. 4. Stretch straight down along wall at least 12 inches (30 cm) until base and strip release. Important: failure to follow instructions carefully may cause damage! Save instructions for damage-free removal or visit command.com. Note: Apply to surfaces above 15 degrees F (-9 degrees C). May lose adhesion below -20 degrees F (-29 degrees C) or above 125 degrees F (51 degrees C). Intended for outdoor use only. Not recommended for use on rough surfaces, such as cement board, brick or rough-sawn wood. Not intended for picture hanging. Hook can be reused with Command® Medium Outdoor Foam Strips.
Always refer to the actual package for the most accurate information