3M. Command strips. Holds on strongly. Comes off cleanly. No surface damage. 1 hook. 2 large strips. Each hook holds 2 kg, 5 LBS. Hook can be reused with Command Adhesive Large Strips. Hook made in China/strips made in U.S.A.
To apply. 1. Clean surface with isopropyl rubbing alcohol, wipe gently, let dry. Do not use household cleaners. Separate strips. 2. Red side. Remove red liner. Press adhesive to hook. 3. Black side. Remove black liner. 4. Press to surface for 10 seconds. 5. Up. Important: for maximum holding strength slide hook off. 6. 30 seconds. And press base firmly for 30 seconds. 7. Down. Slide hook on. 8. 1 hour. Wait 1 hour before use. To remove. 1. Up. Slide hook up to remove from mounting base. 2. Never pull strip towards you. 3. Straight down slowly. Hold base gently to prevent base from snapping fingers. Do not press base against wall. 4. 15" 38cm. Stretch straight down along wall at least 15 inches (38 cm) until base and strip release. Important: failure to follow instructions carefully may cause damage! Save instructions for damage-free removal or visit command.com. Note: apply to surfaces above 50 degrees F (10 degrees C). Adhesive could lose adhesion above 105 degrees F (40 degrees C).
Always refer to the actual package for the most accurate information