3M. Holds most frames up to 18 inches. x 24 inches. Damage-free hanging. Holds strongly. Removes cleanly. Improved holding power. Limited Warranty. Made in USA with US and globally sourced materials.
To apply: 1. Clean surface with isopropyl rubbing alcohol, wipe gently, let dry. Do not use household cleaners. Separate strips. 2. Snap! Press fasteners together until they snap. 3. Back, remove one red liner. Position one set of strips on back of frame, press firmly. Repeat. Remove remaining red liners. 4. Front, 30 seconds, position frame on wall. Important: press each set firmly for 30 seconds. 5. 30 seconds, grab frame at bottom and peel off surface. Do not pull straight toward you to remove. Firmly press all 3 areas of each strip for 30 seconds each. 6. Click! Wait 1 hour to mount frame. Press fasteners firmly together until they click. If item is not level, reposition. Recommended placement: Up to 3 lbs (1.3kg), 8" x 10". Up to 6 lbs (2.7kg), 11" x 17". Up to 12 lbs (5.4kg), 18" x 24". Place lower set 2/3 from top. Tips: Wait minimum 7 days after painting to hang frames. If there is paper backing on frame, remove to attach fastener directly to frame. To remove: 1. Grab bottom corners and remove frame as shown. 2. Never pull strip towards you. 3. Straight down slowly, lightly press top of strip and grab tab, stretch slowly straight down along wall. 4. 12" 30cm, continue stretching at least 12 inches (30cm) until strip releases from wall. Note: apply to surfaces above 50 degrees F (10 degrees C). Adhesive could lose adhesion above 105 degrees F (40 degrees C).
Always refer to the actual package for the most accurate information