3M. 2 hooks, 4 medium strips. Hold 1 kg (3 LBS). Damage-free hanging. Holds strongly. Removes cleanly. Hook made in Taiwan/Strips made in USA with US and globally sources materials.
To apply: 1. Select location. If possible, choose a location where strips are not over grout lines. Important: allow space above hook for removal. 2. Important: Clean & dry surface. Clean surface with isopropyl rubbing alcohol, let dry. Do not use household cleaners to prep the surface. Separate strips. 3. Red side. Remove red liner. Press adhesive to mounting base of hook. 4. Black side. Remove black liner. Press hook to surface for 10 seconds. 5. Up. Important: for maximum holding strength slide hook off. 6. 30 seconds. Press base firmly for 30 seconds. 7. Down. Slide hook on to mounting base. 8. 1 hour. Wait 1 hour before use. To remove. 1. Up. Slide hook up to remove from mounting base. 2. Never pull strip towards you. Strip could break or damage surface if pulled outward. 3. Straight down. Slowly lentamente. Hold base gently to prevent base from snapping fingers. Do not press base against wall. 4. 12" 30cm. Stretch strip straight down along wall at least 12 inches until base and strip release. Note: apply to surfaces above 15 degrees F. adhesive could lose adhesion above 125 degrees F. Not intended for picture hanging. Instead use Command™ Picture Hanging Strips, sawtooth or wire backed hangers. Hooks can be reused with blue Command™ Medium Water Resistant Strips.
Always refer to the actual package for the most accurate information