To apply. 1. Select location if possible, choose a location where strips are not over grout lines. Important: allow space above hook for removal. 2. Important. Cleans & dry surface: clean surface with isopropyl rubbing alcohol, let dry. Do not use household cleaners to prep the surface. Separate strips. 3. Red side. Remove red liner. Press adhesive to mounting base of hook. 4. Black side. Remove black liner. Press hook to surface for 10 seconds. 5. Up. Important: for maximum holding strength slide hook off. 6. 30 seconds. Press base firmly for 30 seconds. 7. Down. Slide hook on to mounting base. 8. 1 hour. Wait 1 hour before use. To remove: 1. Up. Slide hook up to remove from mounting base. 2. Never pull strip towards you. Strip could break or damage surface if pulled outward. 3. Straight down slowly. Hold base gently to prevent base from snapping fingers. Do not press base against wall. 4. 15" 38cm. Stretch strip straight down along wall at least 15 inches until base and strip release. Important: failure to follow instructions carefully may cause damage! Save instructions for damage-free removal or visit command.com. Note: apply to surfaces above 15 degrees F. Adhesive could lose adhesion above 125 degrees F. Towel hook can be reused with the Commandâ„¢ Large Water Resistant Strips.
Always refer to the actual package for the most accurate information