To apply: 1. Works best for smooth surfaces. Important: apply to a clean and dry surface. To clean, use a cloth dampened with water or isopropyl rubbing alcohol. Do not use household cleaners. Separate strips. 2. Remove blue liner. Press adhesive to clip. 3. Remove black "wall side" liner. 4. Press firmly along the entire clip for 30 seconds. Wait 1 hour before use. To remove: 1. Never pull strip towards you. 2. Slowly. Straight down. Hold clip gently to prevent clip from snapping fingers. Do not press clip against wall. 3. Stretch straight down along wall at least 6 inches (15 cm) until strip releases from wall. Important: failure to follow instructions carefully may cause damage! Note: Apply to surfaces above 15 degrees F (-9 degrees C). May lose adhesion below -20 degrees F (-29 degrees C) or above 125 degrees F (51 degrees C). Intended for outdoor use only. Not recommended for use on rough surfaces, such as cement board, brick or rough-sawn wood. Not intended for picture hanging. Use one clip for every 2 feet of lights. Clips can be reused with Command* small outdoor foam strips.
Always refer to the actual package for the most accurate information