To apply: 1. Select location if possible, choose a location where strips are not over grout lines. Important: allow space around hook for removal. 2. Clean & dry surface: clean surface with isopropyl rubbing alcohol, let dry. Do not use household cleaners to prep the surface. Separate strips. 3. Remove blue liner. Press adhesive to the mounting base of hook. Repeat with second strip. 4. Remove black liners. 5. Press to surface for 10 seconds. 6. For optimal holding strength slide hook up to remove from mounting base. 7. Press mounting base firmly for 30 seconds to reach maximum holding strength. 8. Slide hook on to mounting base. 9. Wait 1 hour before use. To remove: 1. Slide hook up to remove from mounting base. Top rack dishwasher safe. 2. Never pull strip towards you. Strip could break or damage surface if pulled outward. 3. Hold base gently to prevent mounting base from snapping fingers. Do not press base against wall. 4. Slowly stretch strip horizontally along wall at least 15 inches (38 cm) until mounting base releases from wall. Remove one strip at a time. Repeat step for second strip. Important: failure to follow instructions carefully may cause damage! Save instructions for damage-free removal or visit command.com. Note: Apply to surfaces above 15 degrees F (-10 degrees C). Adhesive could lose adhesion above 125 degrees F (50 degrees C).
Always refer to the actual package for the most accurate information