3m Command 3M Command Bath Caddy

3m Command 3M Command Bath Caddy

3m Command

Free Delivery

On your first order over $35!

Extra 5% off *

Already have an account? 

Details

•Holds strongly in wet conditions •Damage-Free hanging •Weight Capacity: 7.5 Pounds •Size: Large •Color: Frosted •Package Contents: 1 Caddy, 4 Mounting Bases, 4 Large Strips •Tested and proven to hold better than suction cups •Water
...more >>

Directions

Note: Apply to surfaces above 15 degrees F (-10 degrees C). Adhesive could lose adhesion above 125 degrees F (50 degrees C). Holds strongly: High-strength adhesive works great on a variety of surfaces-tile, fiberglass, painted surfaces, finished wood, mirrors and more. Removes cleanly: Slowly pull the tab straight down for damage-free removal from surface. To add caddy: Prep: 1. Select location if possible, choose a location where strips are not over grout lines. Important: allow space above and below caddy for removal. 2. Important: Clean & dry surface: Clean surface with enclosed isopropyl rubbing alcohol wipe. Let dry. Do not use household cleaners to prep the surface. 3. Attach mounting bases: Slide plastic mounting bases onto back of caddy from the bottom up until they snap into place. 4. Separate strips. Mount: 5. Apply strips: Remove red liners. Apply 1 strip to each mounting base and press firmly. Remove black liners. 6. Position & press: Position and press entire caddy against surface for 5 seconds. 7. Remove caddy: Slide caddy up to remove from mounting bases. Caution: caddy must be removed for time specified in step 9 to prevent adhesive failure. 8. Press firmly: Use your thumb to firmly press all 3 areas of each base for 30 seconds each. Wait: let the adhesive build strength! 9. If mounting in a shower or tub area: use shower at least once and then wait 24 hours to allow adhesive to build strength before attaching caddy. Or. If mounting outside of shower or tub area: wait 1 hour to allow adhesive to build strength before attaching caddy. 10. Attach caddy: Slide caddy back onto mounting bases until it snaps into place. To remove: 1. Remove caddy: Slide caddy up to remove from mounting bases. 2. Hold base lightly: To prevent base from snapping your fingers, lightly hold mounting base. Do not press base against wall. 3. Slowly. Remove strip: Never pull the strip out at an angle. Strip could break or damage surface. Slowly stretch strip straight down along the wall. Stretch strip 15 inches (38cm) until mounting base releases from wall. Remove one strip at a time. Repeat steps with additional strips. Important: Failure to follow instructions carefully may cause damage!

Always refer to the actual package for the most accurate information